WE HAVE ANOTHER VERSION LISTED THAT INCLUDES A 3/32" HEX WRENCH IF YOU NEED THAT TOOL TO INSTALL THIS SCREW

I'm Bill Baldyga, owner & manager of Magnum Airpower LLC. I'm the originator of the upgrade screw kit for TLR models. I did the work to find the right grade-12 screw and mil-spec washer with the perfect fit. I did the destructive and durability testing with several types of firearms and thousands of rounds of ammo to work it all out perfectly. Don't buy from copycat sellers who are blatantly pirating my product with low-grade untested versions, I get dozens of messages every week from customers who tried screw kits others sell only to have them come loose, break, not fit correctly or not fit in a holster. Don't waste your time and money, buy the genuine product from the originator.

 Shown mounted in a 7A, also fits 7X which is the newer version of the 7A and TLR-7, 7 SUB, TLR-8, TLR-8A, TLR-9, TLR-10, TLR-RM, TLR-RM II, TLR-VIR II and the USB rechargeable versions of these models which have different models numbers but are otherwise the same light, all have the same factory mounting-screw.

 This upgrade alloy-steel mounting-screw kit is a lot easier to tighten, loosen and holds a lot more secure and stable than the original factory mounting screw. The main and third photos show this kit installed, the last photo shows the original factory slotted-screw this kit replaces. The screw and spacer-washer sit below-flush on both sides of the weapon-light so it fits with all holster types.

 This kit includes a spacer-washer and the mounting screw as shown in the first two photos, the lights are shown for reference only.

 INSTRUCTIONS :  Completely remove the original factory screw, spring and e-clip from the weapon light, you will not need any of those parts with this screw kit. Install the spacer-washer from the upgrade kit into the socket where the spring was located, then install the upgrade screw through the center of the spacer-washer. Snug the screw moderately, enough to hold the light firmly to the rail. Only 6-7 inch-lbs is recommended, too much torque can bend the screw and cause damage to the weapon-light.